Sensi SupportTouch Wi-Fi ThermostatInstallation › How do I connect the wires to the base of my new Sensi thermostat?

Installation

How do I connect the wires to the base of my new Sensi thermostat?

One by one, push each wire into the corresponding terminal by sliding the exposed wire into the opening on the top of the terminal block. As you push the wire into each terminal the paddles will be pushed down, securing the wire in place. You can give the wire a tug to make sure it’s securely in the terminal. If you need to take the wire back out, push on the paddle at the bottom and pull the wire up to remove it.

After all wires are attached and secure, push the excess wire back into the wall until the base is flush. This allows for more secure mounting.

Reach out to us

Our customer support is available 7 days a week.

Get support